Mirror Panel Installation Instructions

Mirror Panel Installation Instructions

The film is tough, but can be damaged by fingernails or sharp instruments. If cared for properly, it should last indefinitely. Handle by holding along edges, only do not press down on mirror surface with your thumbs when holding mirror along edge. Do not put any weight or object on mirror surface when it is in a horizontal position.

Hardware, already attached to the mirror panel, includes:

  • 4 brackets
  • 4‐#10 self tap screws

Installation instructions

1. It is recommended that two people mount the mirror panel.

2. Every panel has predrilled holes. To install the mirror panel in a horizontal position, remove self tapping screws and brackets. Install them in the holes located approximately 1 9/16” from each corner on the side of the mirror. 

3. Locate position of mirror panel on wall marking the spots for the mounting holes of the brackets.

4. Drill the four holes in the wall using a drill size suitable to the type of wall fastener (not included) you intend to use. The mirror panel can be mounted in two different ways:

Visible Bracket (Holes are located 1 9/16” from the corner)
Hidden Bracket
Hidden Bracket

 

Cleaning Instructions

Before attempting to clean the mirror, use dry compressed air to make sure all dust and debris are off the mirror surface (i.e. Dust Off). To easily clean finger marks or splashes, use a window cleaner by wiping gently with a soft, non‐abrasive cloth. Any dust or hard particles in the cloth or on the mirror may scratch the film surface. Should the film adhere to the backing panel, blow gently into the vent hole in the back of the panel.